Role of Particle Cracking in Dilatation During Tensile Straining of a Cast and Thermomechanically Processed 6061 A1-20 Volume Percent AL2O3 Metal Matrix Composite

1In this work, the dilatation during tensile straining of a cast and thermomechanically processed 6061 Al - Al2O3 metal matrix composite (MMC) containing 20 volume percent of Al2O3 particles was examined. Standard tensile samples of the MMC and unreinforced 6061 Al were machined. Precise diameter measurements were made of both composite and unreinforced samples prior to and immediately following tensile straining. Tension tests were conducted to various strains as well as to fracture and an extensometer was employed to obtain accurate measurement of the axial strain. The MMC material exhibited a continuously increasing dilatation during tensile straining while the unreinforced 6061 control material deformed plastically at constant volume. Careful metallographic preparation revealed particle cracking in all MMC samples throughout the range of strains examined. A clear trend of increased frequency of particle cracking was observed. Void formation and growth due to cracking of the particles was analyzed and shown to correlate with the dilatation observed during tensile straining of the composite. Linkage of such voids is proposed as the mechanism of crack propagation at failure of the MMC.Naval Postgraduate School Monterey CA is the author of 'Role of Particle Cracking in Dilatation During Tensile Straining of a Cast and Thermomechanically Processed 6061 A1-20 Volume Percent AL2O3 Metal Matrix Composite', published 1996 under ISBN 9781423575849 and ISBN 1423575849.